Best Concrete Contractors Greensboro NCResidential & CommercialConcrete Construction

Yes. Driveway replacement in Fisher Park, Westerwood, and College Hill is some of our most common Greensboro work. Many of these homes still have their original slabs, often cracked by red clay movement and tree roots. We handle tear-out, haul-away, base compaction, and a new rebar-reinforced pour, and you pay nothing until the job is finished.

Cost depends on size, finish, and site prep — every job is different. We come out and walk the site with you, then give you a flat, all-in price during the free estimate. No surprise change orders mid-project, and no payment is due until the concrete is poured.

Wait at least 7 days before driving passenger vehicles on new concrete in Greensboro. You can walk on it after 24-48 hours. Heavy equipment, RVs, and box trucks should stay off for the full 28-day cure window. North Carolina's humidity and temperature swings need that time to hit full design strength.

The stamps we use leave a textured surface profile that's naturally non-slip — no different than a real stone or brick surface when wet. For pool decks or shaded patios where extra grip matters, we can mix a non-slip additive into the sealer at no upcharge.

All concrete moves as it cures and as the seasons change — that's why control joints exist. We saw-cut control joints into every slab within hours of the pour so any shrinkage stress releases into the joint instead of the slab face. Combined with a high-strength concrete and steel rebar, that's how we keep slabs from cracking through the field. Anyone promising "crack-free" concrete is either cutting corners or not telling you the truth.

Yes. We install structural steel rebar on every residential slab in Greensboro — no wire mesh substitutes. Rebar increases the tensile strength of the slab and keeps the concrete locked together if a shrinkage crack ever opens up. NC's clay-heavy soils swell and shrink with moisture, and rebar is what keeps the slab flat through those cycles.

4 inches is the standard for residential driveways (cars and SUVs) in Greensboro. We pour 5-6 inches when you've got an RV, dually, or anything regularly over 10,000 lbs. Commercial slabs and pole barn pads get spec'd to the load — we'll match thickness to what's actually rolling over it.

We don't recommend it. Pouring fresh concrete over an old, cracked slab telegraphs every existing crack up through the new surface within a season or two ("reflective cracking"). It also raises your grade and can cause water to pond against the house. Tearing out and re-pouring on a properly compacted gravel base costs more day one but lasts decades longer.

Standard broom-finish driveways and sidewalks don't strictly need sealing — a properly poured high-strength concrete slab with control joints holds up on its own. Where sealing matters is stamped or decorative concrete: a sealer protects the color and the texture. We'll recommend it where it makes sense, not as a default upsell.

Done right — high-strength concrete, properly compacted base, structural rebar, and control joints cut on time — a concrete driveway in Greensboro should last 30 to 50+ years with minimal maintenance. Most of the slabs that fail early do so because the base wasn't prepped, joints were skipped, or the mix was watered down on site. We don't cut those corners.

Yes. When Greensboro requires a permit for your driveway, patio, or pad, we pull it and handle the inspections. We work with the local building department regularly and know what's required for setbacks, impervious surface limits, and right-of-way work.

PSI is the compressive strength of the cured concrete. 3000 PSI is the minimum for residential sidewalks and foot-traffic slabs. We pour high-strength concrete on every driveway and structural slab in Greensboro — it's denser, more freeze-thaw resistant, and significantly more durable under wheel loads. The cost difference per yard is small; the longevity difference is huge.

Light mist is fine — we'll keep going. Heavy rain washes cement paste off the surface and weakens the finish, so we'll reschedule if a real storm is incoming. We watch the radar all day during a pour and tarp the slab if a surprise cell pops up.

A clean, well-finished concrete driveway or patio is one of the highest ROI exterior upgrades. Buyers in Greensboro read a cracked, patched, or gravel drive as deferred maintenance and discount accordingly. Stamped patios, in particular, expand usable outdoor living space — which appraisers and buyers both reward.

Drainage gets designed before the pour. We grade the compacted base and slope the finished slab away from your foundation — typically 1/8" to 1/4" per foot — so water sheets off instead of ponding. On sites where natural slope works against the house, we'll add a trench drain or French drain at the slab edge.

Spalling is when the top surface of the concrete flakes off in chips. It's almost always caused by water sitting in the surface pores and freezing, or by using rock salt / de-icing chemicals on the slab in winter. We use a high-strength concrete air-entrained mix on every pour to resist freeze-thaw damage, and we ask you to never put rock salt on it — sand or calcium chloride only if you absolutely need traction.

Most residential driveways and patios in Greensboro are a 1-3 day job. Day 1: demolition, base prep, forms set, rebar tied, concrete poured and finished, control joints saw-cut within hours of placement. Day 2-3 (when needed): forms come off, site cleanup, any tear-out hauled. Bigger or staged jobs (multi-section pours, decorative work) can stretch longer. Weather like heavy rain or freezing temps can push the start date but doesn't change the work itself.