Best Concrete RV Parking Pad Contractors Greensboro NC

The load math on an RV pad is unforgiving: several tons ride on a handful of tire patches, parked in the same position for months while red clay beneath swells with every wet spell. Our pads answer that with driveway-plus thickness along the wheel tracks, reinforcement throughout, and a base compacted deliberately rather than assumed. Layout gets equal attention — approach angle off the street, door and awning clearance, a level plane so the refrigerator runs right and the jacks barely extend. Around Greensboro we also plan for utilities you may want later, sleeving conduit under the slab before it exists.

In Greensboro specifically, rv parking pad work runs through neighborhoods like Fisher Park, Irving Park, Lindley Park. In pre-war neighborhoods like Fisher Park, Sunset Hills, and Westerwood, we mostly replace original slabs that have reached the end of their life, working around mature oak roots that heave sidewalks and aprons. That local ground truth — not a generic spec sheet — is what the crew builds against when they form up a Greensboro pour.

Our Boat Parking Pad Services

Boat pad work covers more than one shape, and each layout changes the spec on footprint, tie-in, and how the drainage runs.

• Standalone boat pads sized 12x30 for boat and trailer only, up to 12x45 or 14x50 when the tow vehicle stays on the slab
• Extended driveway pads that widen the existing drive to accommodate the trailer alongside daily-driver parking
• Turnaround-style pads with room to swing the trailer without repeated back-and-fill on the yard
• Deep-water rig pads sized for offshore boats and larger tandem or tri-axle trailers
• Pontoon and larger runabout pads with a wider footprint and heavier reinforcement grid
• PWC and small-craft pads on lighter spec when a jet ski trailer or utility trailer is the actual load
• Combination boat plus RV or camper pads where the same slab has to serve both
• Tie-in aprons connecting the pad to the existing driveway with matched thickness across the transition

If the yard has a slope, a wet spot, or a tree line near the pad footprint, we walk it and price the drainage work honestly. Sloping a pad into a low corner without a discharge path usually creates a swamp behind the boat trailer, not a solution.

Why Thickness and Edge Detail Matter on a Boat Pad

A residential driveway is spec'd for a passenger vehicle rolling across the surface. A boat pad is spec'd for a loaded trailer sitting on two axles in the same spot for months at a time, with a heavier tow vehicle briefly loading the same slab during hookup. Those are two very different structural asks. A four-inch pad on a marginal base cracks under a loaded tandem trailer inside a couple of freeze-thaw cycles.

What a proper boat pad spec brings:

• Five to six inches of thickness for boat and trailer only, six inches when the tow vehicle stays on the slab during storage
• Thickened edge (typically eight inches at the perimeter) so trailer jack drop, tongue weight, and tire load at the slab edge don't chip the concrete off
• Compacted aggregate base four to six inches deep for load spreading and drainage under the slab
• Rebar grid or heavy wire mesh sized for the axle load, not the four-inch residential default
• Joint layout that steers cracking into planned lines rather than across the middle of the trailer footprint
• Slope of roughly a quarter-inch per foot away from the boat or toward a drainage path, so hull rinse and rainfall clear the pad instead of pooling under the trailer

Built to spec, a boat pad handles two to three decades of load without the panel failures that show up on under-thick slabs by year five.