Best Concrete Patio Addition Contractors Winston-Salem NC

The hard part of a patio addition is the marriage joint. Old and new concrete differ in age and shrinkage, so we drill and epoxy dowels into the existing edge, pour the addition at matching elevation, and cut the joint pattern to continue the original layout across both sections. Finish matching gets specific attention on this city's older slabs — a decades-old surface carries a weathered texture and tone that fresh concrete won't show for years, so we adjust broom drag to close the gap, and when a seamless look matters more than preserving the original surface, resurfacing both sections together is on the table.

In Winston-Salem specifically, patio addition work runs through neighborhoods like Buena Vista, West End, Washington Park. Ardmore alone holds over 4,000 homes, most from the 1920s-40s, and the original driveways and walkways in Ardmore, West End, and Washington Park are past their design life: spalled, settled, and cracked along the same red-clay seams that run through the whole Triad. That local ground truth — not a generic spec sheet — is what the crew builds against when they form up a Winston-Salem addition.

Our Patio Addition Services

Patio addition work looks simple from the outside — a rectangle poured next to another rectangle. What actually decides whether it looks and holds up as one patio is the tie-in detail and how the base under the new section is built.

• Small extensions to add a grill zone, fire-pit landing, or dining area next to an existing slab
• Full patio expansions that double or triple the original footprint
• Wraparound additions that turn a corner of the house and connect to the existing patio
• Step-down or step-up extensions when the yard grade changes across the addition
• Pergola or screen-room pads added off an existing patio with anchor points planned before the pour
• Connection pours that bridge an existing patio to a new pool deck, walkway, or driveway apron
• Finish and color match on broom, stamped, exposed aggregate, and integral color patios
• Complete tear-out and repour when the existing slab is too far gone to tie into cleanly

Some additions are honestly better done as a full replacement — if the original patio is cracked, sunken, or has a finish that can't be matched, chasing a tie-in on a failing slab just stacks two problems together. We will walk the patio, tell you where you stand, and price both options.

Why the Cold Joint Detail Matters

A patio addition creates a cold joint — the seam where new concrete meets fully cured concrete. That joint is the single most important detail on the job. Done right, it disappears visually and holds tight for decades. Done wrong, it opens up within a season and telegraphs across the whole patio.

What a proper cold joint tie-in looks like:

• The existing slab edge is cleaned back to sound concrete, saw-cut straight if the edge is broken up
• Steel dowel bars are drilled into the existing slab edge on 12-to-18-inch centers, epoxied in place, and extend into the new pour
• The dowels are typically sleeved on the new side so the two slabs can expand and contract independently without shearing the joint
• The new base is compacted to match — or exceed — the compaction of the original base under the existing slab
• The new pour is placed at the exact same finish elevation as the old slab, with the finisher working the seam by hand to blend the surface texture
• A control joint or expansion joint gets tooled or sawed at the cold joint line so any future movement happens along a planned seam

Skipping the dowels is the most common shortcut on patio additions in NC. It saves an hour of drilling and epoxy at the pour and costs a re-crack repair within three to five winters.