Commercial Concrete Pads in Statesville, NC

A commercial concrete pad is a purpose-built slab designed around one piece of equipment or one function — HVAC unit, backup generator, pad-mount transformer, dumpster staging, ADA parking stall, loading zone. The pad's thickness, reinforcement, and edge detail all get set by what sits on top of it and how it interfaces with utilities, drainage, and code inspection. A generic 4-inch broom-finish slab doesn't cut it for a 400-amp transformer or a 6-yard dumpster that gets picked up twice a week.

Local Concrete Contractor pours commercial pads across North Carolina — new equipment installs, replacements, and code-driven upgrades. Every pad starts with a spec: the equipment cut sheet or the utility's standard detail, the mechanical inspector's requirements, the fire marshal's clearance rules where they apply, and the site's drainage plan. That turns into a written scope with thickness, mix design, rebar layout, isolation joints, and pour sequence. Zero deposit, licensed and insured, and the certificate of insurance goes to the GC or property manager before mobilization.

Our Commercial Pad Services

Pads look simple from the outside — a rectangle of concrete — but the spec changes completely depending on what sits on top and who has to inspect it.

• HVAC equipment pads for rooftop units at ground level, split systems, and chillers
• Backup generator pads sized to the genset base and fuel tank footprint
• Pad-mount transformer pads built to Duke Energy or the local utility's standard detail
• Dumpster pads with reinforced edges to survive front-loader tine strikes
• ADA parking pads with the correct cross-slope (max 2 percent in any direction) and access aisle
• Loading zone pads at truck approaches, with thickened edges and dowel bars into the adjacent slab
• Compressor, pump, and mechanical equipment pads on manufacturing and service sites
• Fuel tank pads and containment slabs with sloped drainage to a designated point
• Small-footprint pads for propane tanks, ice machines, exterior storage units, and vending equipment
• Replacement pads for failed or under-spec original pours

Each category above changes the mix, the thickness, and the reinforcement. We won't pour a generator pad to a dumpster spec or vice versa — the load profiles and the cycle counts don't match.

Thickness and Load Rating by Pad Type

The single biggest driver of how long a commercial pad lasts is whether the thickness matches the load. Under-spec pads crack, tilt, and settle inside a couple of seasons. Over-spec pads cost more up front and last decades. The right number sits between them.

• Dumpster pads — 6 to 8 inches, 4000 to 4500 PSI, thickened edge at the front-loader approach, #4 rebar grid on 12-inch centers, sloped to drain away from the building
• HVAC pads — 4 to 6 inches depending on unit weight, 4000 PSI, thickened edge at the equipment feet, sized 6 inches larger than the unit footprint in each direction
• Transformer pads — thickness per utility standard detail (usually 6 to 8 inches), grounding grid embedded per the utility's requirements, coordinated with the utility's mounting hardware
• Generator pads — 6 to 8 inches, 4000 to 5000 PSI, sized to the genset base plus fuel tank footprint, isolated from the building slab with expansion joints
• ADA parking pads — 4 to 6 inches, 4000 PSI, cross-slope max 2 percent in any direction, striping and signage per the site's ADA compliance plan
• Loading zone pads — 7 to 8 inches, 4500 to 5000 PSI, dowel-bar transfer into the adjacent slab, joint spacing tightened to 12 feet on center

We pour to the equipment cut sheet or the utility standard, not to a generic template. If the manufacturer's spec calls for 8 inches with a 12-inch thickened edge, that's what goes on the pad, and we can hand you the cut sheet with the quote.